BlueJammer-V2, BW16-BlueJammer & ZeroWave for Flipper Zero released!
Make your own | Schematics | Hardware layout | PCB's | Demos | Channels | Flashing | 3D case | About | Support me | Website
The ESP32-BlueJammer (Bluetooth jammer, BLE jammer, WiFi jammer, RC jammer) disrupts various devices using an ESP32 and nRF24 modules, causing plenty of noise and sending unnecessary packets (DoS).
It interrupts:
The whole 2.4GHz broadband! Everything that works on 2.4GHz is being interfered, like:
audio in speakers being transmitted over bluetooth, microphones on 2.4GHz, smartphone connections, WiFi, RC Drones (etc.), IoT devices, smart gadgets, wireless keyboard & mouse, just anything on 2.4GHz!
Ideal for controlled disruption and security testing. Based on 2.4GHz communication.
It has a big range (over 30Meters+ - may vary on your antenna and hardware setup!) on newest Bluetooth versions with casual 2.4GHz antennas, you can easily increase this as well by taking some simple "bigger" router antennas. An amplifier (2.4GHz) may be a good option too!
Remember that jamming is illegal and should not be used with malicious intent!
ESP32-RF DIY-PCB:
This PCB can fit an ESP32-wroom-32U/E DevKitC and 2 nRF-modules, along with an 0.96" I2C OLED, LEDs and switches.
Remember: It is not intended for illegal use!
For this one, all you need is listed below:
Required:
- ESP32 Dev Module (Recommended: ESP32-32U CP2102, any ESP32 should work as long as it has the needed pins, 38P required!)
- nRF24L01+PA+LNA (2x)
- 10-100uF Capacitor (2x) (any voltage above 5V)
- 0.96" OLED Display I2C
- Slide Switch (2x)
- LEDs: 3mm LED box
- Resistor kit
- R1 = 1kOhm
- R2, R3, R5, R7 = 47kOhm
- R4, R6 = 100kOhm
Additional: